Blog

1. Source Standardization: Unifying Rules to Prevent Deviations at the Root Unified Templates and Assets: All labels directly adopt the official templates prescribed by the national standard *GB 15258

1. Define Clear Update Triggers: Ensure Immediate Updates Upon Any Change Label updates must be initiated whenever any of the following situations occur: Changes in Formulation/Ingredients: When adjus

I. Content-Related Issues (Highest detection rate, accounting for over 60%) 1. Missing Mandatory Elements: Most commonly, the 24-hour emergency contact number or the supplier's full address is mis

1. Standardize at the Source: Use Official Templates and Prohibit Unauthorized Design Modifications Directly adopt the official templates provided in the Appendix of the national standard GB 15258-200

1. Missing Mandatory Core Elements This is the most common content error; complete labels frequently omit required items: Missing signal words, 24-hour emergency contact numbers, or the full address d

I. Errors Related to Size and Format 1. Non-compliant Dimensions: The overall label or pictogram dimensions fail to meet standards; specifically, using labels that are too small for large-capacity pac

1. Basic Format Verification First, check the label's dimensions and layout: Verify that the minimum label dimensions correspond to the packaging capacity: for packaging >3L, the label must be

1. Design and Production Phase: Strictly Adhere to Compliance Requirements Match Dimensions and Content Specifications: First, determine the minimum dimensions for labels and pictograms based on the p

I. Errors Related to Size and Format These are the errors most frequently detected during import and export inspections: 1. Incorrect Overall Label/Pictogram Dimensions: The dimensions of the entire l

1. Non-compliant Dimensions for Dangerous Goods Transport Labels This is the most common error encountered with export shipments. According to export regulatory requirements, the minimum dimensions fo

I. Optimize Registration Marks at the Design Source to Reduce Alignment Difficulty Establish calibration marks specifically for alignment during the design phase to eliminate deviations at the root: 1

I. Design Phase: Establish Registration Marks in Advance to Eliminate Deviations at the Source 1. Add Standard Registration Marks: Place 0.1mm-thick crosshair registration lines at the four corners an